ACC Radar / Distance Sensor VAG OEM (2Q0907572M)
ACC Radar / Distance Sensor VAG - OEM 2Q0907572M
Genuine VAG ACC radar sensor (distance radar) for vehicles with adaptive cruise control and driver assistance systems.
The radar sensor sits behind the vehicle's emblem and continuously measures the distance to and speed of the traffic ahead. Adaptive cruise control (ACC), the distance warning and the emergency braking assistant (Front Assist) all rely on this signal.
If the radar is faulty, damaged or out of position, these systems fail or are deactivated by the vehicle. After a collision or front-end damage, replacement is often required.
This is a genuine OEM VAG part.
OE numbers
- 2Q0 907 572 M
- 2Q0 907 572 B
Applications
Suitable for the models listed below, among others. Which radar version a vehicle has depends on its equipment level; different versions were fitted within the same model. Always check the OE number of the fitted radar before ordering, or have the application checked against the registration number or the chassis number.
Audi
- Q2 (GA) - from 2017
Volkswagen
- Tiguan (AD) - 2016 to 2024
- Tiguan (BT) - from 2017 to 2024
- Tiguan Allspace (BW) - from 2018
- T-Roc (A1) - 2018 to 2026
- Polo Hatchback (AE) - from 2018
- Polo Sedan / Notchback / Variant (AW) - from 2018
- Crafter (SC) - from 2017, commercial vehicle
- Crafter (SZ) - from 2017, bus
Skoda
- Kodiaq (NS) - 2017 to 2024
- Kodiaq (NV) - from 2018
- Karoq (ND) - from 2018
Seat / Cupra
- Ateca (KH) - from 2016
- Arona (KJ) - from 2018
- Ibiza (KJ) - from 2018
Possible complaints and fault codes
A faulty, misaligned or uncalibrated ACC radar can cause the following complaints, among others:
- Adaptive cruise control unavailable or dropping out while driving
- "Front Assist: fault" or "Driver assistance systems: fault" message in the display
- Distance warning and emergency braking assistant out of operation
- Systems that only fail after a few kilometres of driving
Fault codes in control module 13 – distance control module (J428), among others:
- C110300 – ACC sensor incorrectly adjusted / misaligned
- B200FF0 – internal fault in the distance control module (radar sensor)
A complaint or fault code does not automatically mean the radar is faulty. First check the mounting position and the front bumper for damage or contamination, then the connector and the wiring, and carry out a calibration. If calibration keeps failing or an internal fault is stored in the distance control module (J428), the radar needs to be replaced.
Important fitting information
PLEASE NOTE:
After fitting, the radar sensor must be coded and calibrated with suitable diagnostic equipment. Without correct calibration, the adaptive cruise control and the associated assistance systems will not work, or will not work reliably.
Product information
- Product: ACC radar sensor / distance radar
- Application: VAG, adaptive cruise control and driver assistance
- Quality: Genuine OEM VAG
- Fitting: Coding and calibration required