Which micro switch does your DSG selector lever need? Selection guide 3Q0713128, 5Q0713128A and 3Q0713128A

Melding in het instrumentenpaneel: voertuig alleen in positie P verlaten

Do you get the message "Leave vehicle only in position P" or "Visit workshop, leave vehicle in position P", often together with fault code B116229? In many cases the micro switch in the DSG selector lever is faulty, not the mechatronic unit.

VAG has used three versions of this switch. They look alike but are not interchangeable. Compare your old switch with the photos below and pick the right one. Click a photo to go straight to the product.


Which version do you have?

Micro switch 3Q0713128 - white cover, fixed with 3 screws

1. Micro switch 3Q0713128

How to recognise it: white plastic cover around the selector rod (under the gaiter). The switch is fixed with 3 screws.

Fitted to: Audi A3, S3 and RS3 (8V), including the Cabriolet: these always have this version. Also the VW Golf 7 / 7.5 if the cover under the gaiter is white.

View the 3Q0713128 →

Micro switch 5Q0713128A - black cover with wings and clips

2. Micro switch 5Q0713128A

How to recognise it: black plastic cover around the selector rod. The switch has 'wings' with clips on the sides and one screw from the side.

Fitted to: VW Golf 7 / 7.5 with a black cover, VW Beetle (5C), Skoda Octavia III (5E) and Seat Leon III (5F). Not the Audi A3.

View the 5Q0713128A →

Micro switch 3Q0713128A - fixed with screws in the housing

3. Micro switch 3Q0713128A

How to recognise it: the switch is fixed with screws in the housing; no wings with clips.

Fitted to: Skoda Kamiq, Skoda Scala, Audi Q2 and Audi Q3 (from 2018).

View the 3Q0713128A →

What it looks like under the gaiter

Click the photo that matches what you see in your car.

Do you drive a Skoda Kamiq, Skoda Scala, Audi Q2 or Audi Q3 (from 2018)? Then you need the 3Q0713128A.

Note for the Golf 7 / 7.5: both the white version (3Q0713128) and the black version (5Q0713128A) are used in this model. The model year is therefore not decisive. Always check the colour of the cover under the gaiter or the part number on the old switch.


How to check in two minutes

  1. Unclip the gear lever gaiter from the centre console and slide it up.
  2. Look at the plastic cover around the selector rod: white or black?
  3. Check how the switch is fixed: 3 screws (3Q0713128), wings with clips (5Q0713128A) or screws in the housing (3Q0713128A).
  4. Is there a part number on the old switch? Compare it with the numbers above.

Golf 8 and other models with an electronic gear selector

The Golf 8, Audi A3 (8Y), Skoda Octavia IV and Seat Leon IV no longer have a conventional gear lever but an electronic gear selector. There is no separate micro switch in it. The fault (code P27F500, warning "Error: selector lever") is in the shift solenoid of the gear selector.

For the Transporter T5 and T6.1 the micro switches are not available separately. We can overhaul the shift mechanism; please contact us.


Not sure?

Send us the VIN, ideally with a photo of the cover under the gaiter, to info@lohuissolutions.nl. We will check it for you so you order the right switch first time.